Family for electrical panel in Revit MEP

[google tranlation]

Setting up an electrical system in Revit MEP requires the adaptation of certain families to the standards in force in the country to perform the project. The following short video explains how to be the most appropriate configuration of the family of a panel board for the Iberian Peninsula. In previous articles explaining how to set a light to be accepted by an electrical panel and a system in Revit MEP. I leave you with the video.

http://www.youtube.com/watch?v=KvOxj-aHdXc

Downlight Family, the electrical connector

Explanation of the basic parameters to configure a downlight, example deployable to any non-fluorescent lighting fixture, connected to a single phase power system with a voltage of 230V.

On the Autodesk WikiHelp page there is an explanation for each parameter seen in the video above. It is a good starting point to understand these type of connectors.

http://wikihelp.autodesk.com/Revit/enu/2013/Help/00001-Revit_He0/0328-Build_th328/0971-MEP_Mode971/1038-Electric1038/1156-Using_th1156/1159-Circuit_1159